何怡刚,谢 望,施天成,许水清,高 贺.基于畸变电流的直驱式永磁风电变流器 故障诊断研究[J].电子测量与仪器学报,2021,35(8):20-28
基于畸变电流的直驱式永磁风电变流器 故障诊断研究
Study on fault diagnosis of direct drive permanent magnet windpower converter based on distorted current
  
DOI:
中文关键词:  风力发电  直驱式永磁风电变流器  故障诊断  电流信号  状态监测
英文关键词:wind power generation  direct-drive permanent magnet wind power converter  fault diagnosis  current signal  condition monitoring
基金项目:国家自然科学基金(51977153,51977161,51577046)、国家自然科学基金重点项目(51637004)、国家重点研发计划“重大科学仪器设备开发”项目(2016YFF0102200)、装备预先研究重点项目(41402040301)资助
作者单位
何怡刚 1. 合肥工业大学 电气与自动化工程学院 
谢 望 1. 合肥工业大学 电气与自动化工程学院 
施天成 2. 国网安徽省电力有限公司经济技术研究院 
许水清 1. 合肥工业大学 电气与自动化工程学院 
高 贺 1. 合肥工业大学 电气与自动化工程学院 
AuthorInstitution
He Yigang 1. School of Electrical and Automation Engineering, Hefei University of Technology 
Xie Wang 1. School of Electrical and Automation Engineering, Hefei University of Technology 
Shi Tiancheng 2. Economic Research on State Grid Anhui Electric Power Company 
Xu Shuiqing 1. School of Electrical and Automation Engineering, Hefei University of Technology 
Gao He 1. School of Electrical and Automation Engineering, Hefei University of Technology 
摘要点击次数: 700
全文下载次数: 1111
中文摘要:
      针对直驱式永磁风电变流器开关管开路故障诊断的问题,提出了一种基于机侧电流畸变规律的故障诊断方法。 该方法 研究了在不同开路故障类型下的机侧三相电流的畸变规律,总结畸变规律并设计诊断变量,实时监测低通滤波后的机侧三相电 流并计算诊断变量,然后根据诊断变量得出诊断信号,最后根据诊断信号完成实时故障诊断,并在单管故障诊断方法的基础上 提出了支持双管故障诊断的方法。 实验结果表明,该方法对单管故障和双管故障均能进行准确且快速的诊断,诊断成本较低, 鲁棒性较好,不容易出现误诊和漏诊。
英文摘要:
      Aiming at the problem of open circuit fault diagnosis of direct drive permanent magnet wind power converter, a fault diagnosis method based on generator side current distortion law is proposed. This method studies the distortion law of three-phase current under different open circuit fault types, summarizes the distortion law and designs diagnostic variables, monitors the three-phase current of generator side after low-pass filtering in real time and calculates diagnostic variables, then obtains diagnostic signals according to the diagnostic variables, and finally completes real-time fault diagnosis according to the diagnostic signals, On the basis of single tube fault diagnosis method, a method supporting double tube fault diagnosis is proposed. The experimental results show that this method can diagnose single tube fault and double tube fault accurately and quickly, with low cost, good robustness and less misdiagnosis and missed diagnosis.
查看全文  查看/发表评论  下载PDF阅读器